Panasonic PT-RQ25K Series

Chapter 3 Basic Operations — Operating with the remote control
98 - ENGLISH
Note
f The hide condition of the on-screen display can also be canceled by pressing the <MENU> button on the control panel for at least three
seconds while the on-screen display is off (hidden).
Switching the display position of the menu screen
By directly calling up the [ON-SCREEN DISPLAY] screen without operating from the main menu screen, the
display position of the menu screen (OSD) can be easily changed.
button
1) Press and hold the <ON SCREEN> button for at least one second.
f The [ON-SCREEN DISPLAY] screen is displayed while the cursor is in [OSD POSITION] state.
2) Press qw to switch the [OSD POSITION] setting.
f The display position of the menu screen (OSD) will switch each time you press qw.
Note
f Display position of the menu screen (OSD) can also be changed with the menu operation. For details, refer to “Setting [OSD POSITION]”
(x page 156).
Switching the image aspect ratio
Switch the image aspect ratio according to the input.
button
1) Press the <ASPECT> button.
f The setting will change each time you press the button.
Note
f The aspect ratio of the image can also be switched using the menu operation. Refer to the [POSITION] menu → [ASPECT] (x page 118)
for details.
Using the function button
By assigning the following functions to the <FUNCTION> button, it can be used as a simplied shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORM MONITOR],
[LENS MEMORY LOAD], [LEFT/RIGHT SWAP] (PT-RZ24K and PT-RZ17K only), [PROJECTION METHOD],
[GEOMETRY]
button
1) Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 200).
The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
Displaying test patterns
To check the condition of the projector, ten internal test patterns and up to three user registered test patterns can
be displayed.
button
1) Press the <TEST PATTERN> button.
f The test pattern and the main menu screen is displayed.
f If the [TEST PATTERN] screen (list format) is displayed, proceed to Step 3).