Panasonic PT-RQ25K Series

Chapter 4 Settings — [NETWORK] menu
222 - ENGLISH
9) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [OK], and press the <ENTER> button.
f Setting for the IPv4 address is saved.
11) Press the <MENU> button.
f The [WIRED LAN] screen is displayed.
12) Press as to select [IPv6 SETTINGS], and press the <ENTER> button.
f The [IPv6 SETTINGS] screen is displayed.
13) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[AUTO CONFIGURATION]
[ON]
Select this item when assigning the IPv6 address automatically.
Set [TEMPORARY ADDRESS].
[OFF]
Select this item when setting the IPv6 address manually.
Set [IP ADDRESS], [PREFIX LENGTH], and [DEFAULT
GATEWAY].
[TEMPORARY ADDRESS]
[ON] Select this item when the temporary IPv6 address is used.
[OFF] Select this item when the temporary IPv6 address is not used.
[IP ADDRESS] Enter the IP address.
[PREFIX LENGTH] [1] - [128]
Select the prex length.
(Factory default setting: [64])
[DEFAULT GATEWAY] Enter the default gateway address.
14) Press as to select [STORE], and press the <ENTER> button.
f The conrmation screen is displayed.
15) Press qw to select [OK], and press the <ENTER> button.
f Setting for the IPv6 address is saved.
Note
f When using a DHCP server, conrm that the DHCP server is running.
f Consult your network administrator regarding the IP address, subnet mask, default gateway, and prex length.
f [IPv6] in [IP VERSION] cannot be set in following cases.
g When the [NETWORK] menu → [NETWORK CONTROL] → [Crestron Connected(TM)] is set to [ON]
g When the [NETWORK] menu → [Art-Net] → [Art-Net SETUP] is set to anything other than [OFF]
f [IPv4 SETTINGS] cannot be set when the [NETWORK] menu → [Art-Net] → [Art-Net SETUP] is set to [ON(2.X.X.X)] or [ON(10.X.X.X)].
f The network settings for the <LAN> terminal equipped on the projector as standard and the <DIGITAL LINK IN/LAN> terminal on the
optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) are common.
f Wired LAN and wireless LAN cannot be used in the same segment.
[WIRELESS LAN]
Set the connection method of wireless LAN and its details.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50 Series) to the <USB> terminal.
1) Press as to select [WIRELESS LAN].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[ENABLE]
Select this item when the wireless LAN is to be used.
A device such as a smartphone can be directly connected to the projector even if a wireless LAN
access point is not set up separately because the projector is used as a simplied access point.
For setting procedure of the connection key, refer to “Setting the connection key” (x page 223).
[DISABLE] Select this item when the wireless LAN is not to be used.
Note
f [WIRELESS LAN] cannot be set if the optional Wireless Module (Model No.: AJ-WM50 Series) is not attached to the <USB> terminal.
f Maximum number of devices that can be connected simultaneously to the projector via wireless LAN is four devices.