Chapter 1 Preparation — About your projector
34 - ENGLISH
Projector body
2 34
5 6
5
6 6
12 13 14
85 5
7
1
9 1110
Front
Side
Rear
15234 16
Projection direction
BottomTop
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT>
Indicates the status of the light source.
4 Temperature indicator <TEMP>
Indicates the internal temperature status.
5 Adjustable feet
Adjusts the projection angle.
6 Intake vent
7 Remote control signal receiver (rear)
8 Exhaust vent
9 Control panel (x page 35)
10 Security slot
This security slot is compatible with the Kensington security
cables.
11 Connecting terminals (x page 36)
12 <MAIN POWER> switch
Turns on/off the main power.
Connect the supplied power cord.
14 Power cord holder
15 NFC touch point
This is the touch point when using the near eld communication
(NFC, Near Field Communication) function. A device such as a
smartphone equipped with the NFC function can be connected
to the projector by holding it near the touch point.
16 Security bar
A wire, etc., can be attached to prevent theft.
Attention
f Do not block the intake/exhaust vents of the projector.
To Next Page
Loading...
