Chapter 4 Settings — [3D SETTINGS] menu
134 - ENGLISH
[3D SETTINGS] menu
(PT-RZ24K and PT-RZ17K only)
On the menu screen, select [3D SETTINGS] from the main menu, and select an item from the sub-menu.
Refer to “Navigating through the menu” (x page 102) for the operation of the menu screen.
[3D SYSTEM SETTING]
Set the image display method to be used during 3D signal input, according to the 3D system in use.
1) Press as to select [3D SYSTEM SETTING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[SINGLE]
During 3D signal input, images for the left eye and right eye are alternately displayed using the frame
sequential format.
[DUAL (LEFT)] Only images for the left eye are displayed during 3D signal input.
[DUAL (RIGHT)] Only images for the right eye are displayed during 3D signal input.
Note
f When 2D images are input, 2D images are displayed regardless of the [3D SYSTEM SETTING] settings.
[3D SYNC SETTING]
Set the way in which the <3D SYNC 1 IN/OUT> terminal and the <3D SYNC 2 OUT> terminal will be used.
Attention
f Before connecting external devices to the <3D SYNC 1 IN/OUT> terminal and the <3D SYNC 2 OUT> terminal using cables, complete the
[3D SYNC MODE] setting and conrm that the external devices to be connected are turned off.
f Changing the [3D SYNC MODE] setting while the cables are connected may result in malfunctions of the projector or the connected external
devices.
1) Press as to select [3D SYNC SETTING].
2) Press the <ENTER> button.
f The precaution message related to [3D SYNC SETTING] is displayed.
3) Press the <ENTER> button.
f The [3D SYNC SETTING] screen is displayed.
4) Press as to select [3D SYNC MODE].
5) Press qw to switch the item.
[3D SYNC MODE] Details to be set in [3D SYNC1] Details to be set in [3D SYNC2]
[OFF] Not used. Not used.
[1] 3D trigger output Stereo sync output
[2] 3D trigger output 3D trigger output
[3] Stereo sync input Through 3D SYNC1
[4] Stereo sync input Stereo sync output
[5] Stereo sync input 3D trigger output
[6] Frame sync input Through 3D SYNC1
[7] Frame sync input Stereo sync output
[8] Frame sync input 3D trigger output
[9] 3D trigger output Frame sync output
[10] Stereo sync output Frame sync output
[11] 3D IR TRANSMITTER (+) output 3D IR TRANSMITTER (
-
) output
6) When [1], [4], [7], or [10] is selected, press as to select [STEREO SYNC OUTPUT DELAY], and press
qw to set the amount of delay for output.
[0us] - [25000us] Sets the amount in 10 us increments.
f To synchronize multiple projectors to display 3D images, use a frame sync input and output.
To Next Page
Loading...
