Chapter 2 Getting Started — Connecting
ENGLISH - 69
Connecting example when using the contrast synchronization function/shutter
synchronization function
In a case to construct a multi-display by linking projected images from multiple projectors, following functions can
be used by synchronizing multiple projectors using the <MULTI SYNC IN> terminal and the <MULTI SYNC OUT>
terminal.
f Contrast synchronization function
A linked screen with balanced contrast can be displayed by sharing the brightness level of the image signal
displaying in each projector.
To use this function, set the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] for each linked
projector as follows.
g Set [MULTI PROJECTOR SYNC] → [MODE] to anything other than [OFF].
Set [MODE] to [MAIN] only on one projector that is linked. Set [MODE] to [SUB] for all other projectors.
g Set [MULTI PROJECTOR SYNC] → [CONTRAST SYNC] to [ON].
Unify the [CONTRAST MODE] setting in the [PICTURE] menu → [DYNAMIC CONTRAST] for each linked
projector to [1] or [2]. If there is any projector that does not have the [CONTRAST MODE] setting menu, unify
the setting to [1].
f Shutter synchronization function
This is a function to synchronize the shutter operation of the specied projector to other projectors, and the
effect using the shutter function including the fade in/fade out operation can be synchronized.
To use this function, set the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] for each linked
projector as follows.
g Set [MULTI PROJECTOR SYNC] → [MODE] to anything other than [OFF].
Set [MODE] to [MAIN] only on one projector that becomes the synchronization source within the linked
projectors. Set [MODE] to [SUB] for all other projectors.
g Set [MULTI PROJECTOR SYNC] → [SHUTTER SYNC] to [ON].
Unify the [CONTRAST MODE] setting in the [PICTURE] menu → [DYNAMIC CONTRAST] for each linked
projector to [1] or [2]. If there is any projector that does not have the [CONTRAST MODE] setting menu, unify
the setting to [1].
To Next Page
Loading...
