Panasonic PT-RQ25K Series

Chapter 4 Settings — [ADVANCED MENU] menu
ENGLISH - 131
3) Press the <ENTER> button.
f The [EDGE BLENDING] screen is displayed.
4) Press as to select [BLACK LEVEL ADJUST].
5) Press the <ENTER> button.
f The [BLACK LEVEL ADJUST] screen is displayed.
6) Press as to select [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE SHAPE], or [RIGHT
FREE SHAPE] to initialize.
7) Press the <ENTER> button.
f The [UPPER FREE SHAPE] screen, the [LOWER FREE SHAPE] screen, the [LEFT FREE SHAPE]
screen, or the [RIGHT FREE SHAPE] screen is displayed.
8) Press as to select [INITIALIZE].
9) Press the <ENTER> button.
f The conrmation screen is displayed.
10) Press qw to select [EXECUTE], and press the <ENTER> button.
Note
f The adjustment data for [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE SHAPE], and [RIGHT FREE SHAPE] cannot be
initialized at once.
f To initialize all the adjustment data, select each item and execute [INITIALIZE] individually.
f When the projector is initialized by one of the following methods, all data in [UPPER FREE SHAPE], [LOWER FREE SHAPE], [LEFT FREE
SHAPE], and [RIGHT FREE SHAPE] are initialized.
g When initialized by selecting the [PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
g When initialized by setting the [PROJECTOR SETUP] menu → [INITIALIZE] → [USER SETTINGS] → [OTHER USER SETTING] to
[INITIALIZE]
[FRAME RESPONSE]
Set the processing method of the image frame delay.
1) Press as to select [FRAME RESPONSE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL] Standard setting.
[FIXED]
*1
Sets image frame delay to be constant regardless of the image position or magnication.
*1 Only when video signal or computer signal with the vertical scanning frequency of 50 Hz or 60 Hz is input
[FRAME DELAY]
Set the additional delay time against the frame delay status by the [FRAME RESPONSE] setting.
1) Press as to select [FRAME DELAY].
2) Press the <ENTER> button.
f The [FRAME DELAY] screen is displayed.
3) Press qw to switch the item.
f The items will switch each time you press the button.
[ - 100.00ms] - [+100.00ms]
Sets the delay in 0.01 ms increments.
(Factory default setting: [+0.00ms])
f The delay time (approximate) from the point the image signal is input until the image is projected is
displayed in [ACTUAL DELAY] of the [FRAME DELAY] screen.
Note
f Set this function between [+0.00ms] and [+100.00ms] when the [PROJECTOR SETUP] menu → [MULTI PROJECTOR SYNC] → [MODE] is
set to [OFF].