Chapter 3 Basic Operations — Projecting
ENGLISH - 91
f [LENS CALIBRATION] cannot be executed when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set to [NOT SELECTED].
f For details of operation, refer to the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION] (x page 177).
f The origin position of the lens mounter and the home position of the projection lens are automatically updated when the lens shift calibration
is performed. The home position is an origin position of the lens shift (vertical position and horizontal position of the lens) based on the
calibration result. It does not match with the optical image center position.
f The home position varies depending on the projection lens type. For details, refer to “Lens shift range” (x page 92).
Moving the projection lens to the home position
Operate in following procedure to move the projection lens to the home position.
When operating from the main menu
1) Press the <MENU> button.
f The [MAIN MENU] screen is displayed.
2) Press as to select [PROJECTOR SETUP].
3) Press the <ENTER> button.
f The [PROJECTOR SETUP] screen is displayed.
4) Press as to select [LENS].
5) Press the <ENTER> button.
f The [LENS] screen is displayed.
6) Press as to select [LENS HOME POSITION].
7) Press the <ENTER> button.
f The conrmation screen is displayed.
8) Press qw to select [OK], and press the <ENTER> button.
f The projection lens is moved to the home position.
Note
f [PROGRESS] is displayed in the menu while the projection lens is moved to the home position.
f The [HOME POSITION] screen can also be displayed by pressing the <LENS> button on the control panel or the <SHIFT> button on the
remote control for three seconds or longer.
f [LENS HOME POSITION] cannot be executed when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set to [NOT
SELECTED].
f [LENS HOME POSITION] will not operate correctly when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set incorrectly.
Change the setting if the type is different from the projection lens attached to the projector.
f The home position does not match with the optical image center position.
f The home position varies depending on the projection lens type. For details, refer to “Lens shift range” (x page 92).
f The home position of the Fixed-focus Lens (Model No.: ET-D75LE95) may deviate from the designed position.
When operating from the lens shift adjustment screen
1) Press the <DEFAULT> button on the remote control while displaying the lens shift adjustment screen.
f The conrmation screen is displayed.
2) Press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed in the [HOME POSITION] screen, and the projection lens is moved to the origin
position.
Note
f The [HOME POSITION] screen can also be displayed by pressing the <LENS> button on the control panel or the <SHIFT> button on the
remote control for three seconds or longer.
f The [HOME POSITION] screen is not displayed when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set to [NOT
SELECTED].
f The projection lens is not moved to the correct home position when the [PROJECTOR SETUP] menu → [LENS] → [LENS TYPE] is set
incorrectly. Change the setting if the type is different from the projection lens attached to the projector.
f The projection lens is not moved to the correct home position when the [PROJECTOR SETUP] menu → [LENS] → [LENS CALIBRATION]
is not executed.
f The home position varies depending on the projection lens type. For details, refer to “Lens shift range” (x page 92).
f The home position of the Fixed-focus Lens (Model No.: ET-D75LE95) may deviate from the designed position.
To Next Page
Loading...
