Chapter 3 Basic Operations — Switching on/off the projector
72 - ENGLISH
Switching on/off the projector
Connecting the power cord
Make sure that the supplied power cord is securely xed to the <AC IN> terminal of the projector to
prevent it from being removed easily.
Conrm that the <MAIN POWER> switch is on the <OFF> side before connecting the supplied power cord.
Use the power cord matching with the power supply voltage and the shape of the outlet.
For details of power cord handling, refer to “Read this rst!” (x page 5). For the shape of the outlet, refer to
“Usable outlet” (x page 42).
Note
f The maximum value of light output is limited to 15 000 lm or less when using the projector with AC 100 V to AC 120 V. However, the
maximum value of light output is further decreased in following cases.
g When the Function Board is installed in the slot
g When the light source is deteriorating from use or when there is dust on the optical parts
f The supplied power cords vary depending on the country or region where you purchased the product.
How to attach the power cord
Fig. 3 Fig. 4
Fig. 2Fig. 1
Power cord holder
1) Confirm that the power cord holder is raised so that the power cord can be inserted. (Fig. 1)
2)
Check the shapes of the <AC IN> terminal on the side of the projector and the power cord connector
,
then insert the connector completely in the correct direction. (Fig. 2)
3) Lower the power cord holder. (Fig. 3)
4) Press down the power cord holder until the end of the power cord holder snaps onto the power cord
to secure the power cord. (Fig. 4)
f When pressing down and snapping the power cord holder onto the power cord, hold the power cord from
the opposite side to avoid excessive force to be applied on the <AC IN> terminal.
To Next Page
Loading...
