Chapter 1 Preparation — Precautions for use
24 - ENGLISH
f Do not stack three or more projectors.
f Do not simultaneously use both projectors when stacked on top of each other.
When stacking two projectors, use only one projector at a time and make the other as a backup device. Take a
measure to prevent sliding off just in case.
f Do not use the projector supporting it by the top.
f Do not block the intake/exhaust vents of the projector.
f Prevent hot and cool air from the air conditioning system or exhaust of other projectors from blowing directly to
the intake/exhaust vents of the projector.
100 mm (3-15/16") or shorter100 mm (3-15/16") or shorter
500 mm (19-11/16") or longer300 mm (11-13/16") or longer
200 mm (7-7/8") or longer
f Do not install the projector in a conned space.
When installing the projector in a conned space, provide air conditioning or ventilation separately. Exhaust heat
may accumulate when the ventilation is not enough, triggering the protection circuit of the projector.
100 mm (3-15/16") or longer
500 mm (19-11/16") or longer300 mm (11-13/16") or longer
200 mm (7-7/8") or longer
f When installing and xing the projector on a ceiling or wall using a mount, make sure that the xing screw or
power cord does not come in contact with the metal section inside the ceiling or wall. Failure to observe this
may result in electric shocks.
f Panasonic Connect Co., Ltd. takes no responsibility for any damage to the product caused by an inappropriate
choice of location for installing the projector, even if the warranty period of the product has not expired.
f Immediately remove the product that is not in use anymore by asking a qualied technician.
To Next Page
Loading...
