Chapter 5 Operations — Using the data cloning function
290 - ENGLISH
10) Once the copying of the data is completed, disconnect the USB memory from the <USB> terminal.
11) Turn on the power of the projector.
f The copied content is reected to the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The light source indicator <LIGHT> and the temperature indicator <TEMP> of the copy destination projector blink while copying the data.
Conrm that the blinking of the indicators stops, and then turn on the projector.
To Next Page
Loading...
