Chapter 4 Settings — [DISPLAY OPTION] menu
ENGLISH - 161
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [FADE-IN] or [FADE-OUT].
4) Press qw to switch the item.
Item Adjustment
[FADE-IN]
[FADE-OUT]
[OFF] Does not set fade-in or fade-out.
[0.5s] - [10.0s]
Sets the fade-in or fade-out time.
Select an item from [0.5s] - [4.0s], [5.0s], [7.0s], or [10.0s]. [0.5s] -
[4.0s] can be selected in increments of 0.5.
Note
f Press the <SHUTTER> button on the remote control or the control panel during fade-in or fade-out to cancel the fade operation.
Setting [STARTUP]
Automatically enable/disable the shutter function (shutter: closed/opened) when the power is turned on.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [STARTUP].
4) Press qw to switch the item.
[OPEN]
The projector goes into projection mode with the shutter function disabled (shutter: opened) when the
power is turned on.
[CLOSE]
The projector goes into projection mode with the shutter function enabled (shutter: closed) when the
power is turned on.
Setting [SHUT-OFF]
Sets to automatically opens/closes the mechanical shutter when the power is turned off.
1) Press as to select [SHUTTER SETTING].
2) Press the <ENTER> button.
f The [SHUTTER SETTING] screen is displayed.
3) Press as to select [SHUT-OFF].
4) Press qw to switch the item.
[CLOSE]
The projector goes into standby mode with the mechanical shutter closed when the projector is
switched off.
[KEEP CURRENT STATE]
The projector goes into standby mode with the condition of the mechanical shutter maintained when
the projector is switched off.
[OPEN]
The projector goes into standby mode with the mechanical shutter opened when the projector is
switched off.
Note
f Even if [MECHANICAL SHUTTER] is set to [DISABLE], the projector will go into the standby status with the mechanical shutter closed when
[SHUT-OFF] is set to [CLOSE] and the power is turned off.
To Next Page
Loading...
