Panasonic PT-RQ25K Series

Chapter 4 Settings — [PROJECTOR SETUP] menu
184 - ENGLISH
8) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Performs automatic correction by this projector alone without synchronizing with other projectors.
The duration that the constant brightness is kept will become longer by setting the value of [LIGHT
OUTPUT] smaller.
[GROUP A]
[GROUP B]
[GROUP C]
[GROUP D]
Performs automatic correction by synchronizing multiple projectors.
Up to four groups (A to D) can be set within the same network by using the network function.
You can register and synchronize up to eight projectors in one group.
9) Press as to select [REGULAR CALIBRATION].
10) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF] Does not measure the brightness and color of the light source periodically.
[ON]
Measures the brightness and color of the light source by the brightness sensor at the time specied
by [CALIBRATION TIME].
f Proceed to Step 15) when [OFF] is selected.
11) Press as to select [CALIBRATION TIME].
12) Press the <ENTER> button.
f The projector is in the adjustment mode (the time is blinking).
13) Press qw to select “hour” or “minute”, and press as or the number (<0> - <9>) buttons to set a
time.
f Selecting “hour” allows setting of only the hour in increments of one hour, and selecting “minute” allows
setting of only the minute in increments of one minute between 00 and 59.
14) Press the <ENTER> button.
f [CALIBRATION TIME] is set.
15) Press as to select [CALIBRATION MESSAGE].
16) Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
Displays the time to complete the measurement while the brightness and color of the light source are
measured by the brightness sensor.
[OFF] Does not display a message during the measurement.
17) Press as to select [APPLY].
18) Press the <ENTER> button.
f When [CONSTANT MODE] is set to anything other than [OFF] and the <ENTER> button is pressed in
following cases, the brightness and color of the light source at that time is set as the correction target for the
brightness and white balance of the screen, and the automatic correction will start.
g When [CONSTANT MODE] is set to anything other than [OFF] for the rst time after purchasing the
projector
g When [CONSTANT MODE] is set to anything other than [OFF] for the rst time after executing the
[PROJECTOR SETUP] menu → [INITIALIZE] → [FACTORY RESET]
f When [CONSTANT MODE] was previously set to anything other than [OFF], and the correction target for
the brightness and the white balance is already set, pressing the <ENTER> button displays the conrmation
screen. Proceed to Step 19).
f When [LINK] is set to [GROUP A] to [GROUP D] and the <ENTER> button is pressed, the group name is
displayed on the screens of the projectors that have been set as the same group.
LINK GROUP A
19) Press qw to switch the item.
f The items will switch each time you press the button.