Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 203
Displaying the details of the temperature information
Details of the temperature information of each part inside the projector can be checked.
1) Press the <DEFAULT> button while the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [TEMPERATURE INFORMATION].
f The items will switch each time you press the button.
[ERROR INFORMATION] Displays the detailed screen of the error information.
[TEMPERATURE
INFORMATION]
Displays the detailed screen of the temperature information.
3) Press the <ENTER> button.
f The detailed screen of the temperature information is displayed (English only).
Note
f Select [ERROR INFORMATION] in Step 2) to display the detailed screen of the error information (English only).
Sending status content via E-mail
The status content can be sent to the E-mail address (up to two addresses) set in “[E-mail set up] page”
(x page 267).
1) Press the <ENTER> button while the 1/6 to 5/6 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SEND E-MAIL].
3) Press the <ENTER> button.
f The [SELECT E-MAIL ADDRESS] screen is displayed.
4) Press as to select the destination.
5) Press the <ENTER> button.
f The conrmation screen is displayed.
6) Press qw to select [OK], and press the <ENTER> button.
f The status content is sent.
Saving status content in USB memory
The status content can be saved in a USB memory attached to the <USB> terminal.
1) Press the <ENTER> button while the 1/6 to 5/6 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SAVE TO USB MEMORY].
3) Press the <ENTER> button.
f The conrmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f The status content is saved.
Note
f For the USB memory that can be used with the projector and handling of the memory, refer to “Using the USB memory” (x page 96).
To Next Page
Loading...
