Chapter 5 Operations — Using the web control function
ENGLISH - 251
Note
f The edit screen can be displayed by clicking [USER1], [USER2], or [USER3] registered with test pattern in the test pattern selection buttons
displayed on the right side of the control page.
[LENS] page
Click [Projector control] → [Detail control] → [LENS].
2
1
3
4
5
6
7
8
11
9
10
1 [CALIBRATION]
The calibration execution page (x page 252) is displayed.
2 [SET POSITION]
The lens position setting page (x page 253) is displayed.
3 [HOME POSITION]
Moves the projection lens to the home position.
4 Slider bar
Adjusts the lens shift, zoom, and focus by dragging the slide
button in the center over the slide rail. The operation speed will
become faster when the drag position is further away from the
center.
5 Adjustment buttons
Click asqw to adjust the lens shift, zoom, and focus.
6 [FOCUS]
Use the slider bar or as to adjust the focus.
The adjustment can be performed in two operating speeds by
the position which the slide button is dragged to.
Click as to make ne adjustments. The adjustment can be
performed faster by holding down.
7 [ZOOM]
Use the slider bar or as to adjust the zoom.
The adjustment can be performed in two operating speeds by
the position which the slide button is dragged to.
Click as to make ne adjustments. The adjustment can be
performed faster by holding down.
8 [SHIFT]
Use the slider bar or asqw to adjust the lens shift (vertical
position and horizontal position).
The adjustment can be performed in three operating speeds by
the position which the slide button is dragged to.
Click asqw to make ne adjustments. The adjustment can
be performed faster by holding the button for three seconds or
longer.
9 [SAVE]
Saves the current lens position (vertical position, horizontal
position, focus position, and zoom position) by selecting the
number of the lens memory. Operate following the instruction
displayed in the screen.
10 [LOAD]
Loads the lens position (vertical position, horizontal position,
focus position, and zoom position) saved in the specied lens
memory, and automatically moves to that position. Operate
following the instruction displayed in the screen.
11 [Back]
Returns to the [Detail control] page.
To Next Page
Loading...
