Chapter 5 Operations — Using the information monitor function
280 - ENGLISH
Operation Adjustment Range of adjustment
Press w.
The information monitor becomes bright.
30 % - 100 %
(Factory default setting: 100 %)
Press q.
The information monitor becomes dark.
Note
f [BRIGHTNESS] is adjusted in increments of 10.
f This setting item is common with the following menu item in the on-screen menu.
g The [PROJECTOR SETUP] menu → [INFO MONITOR SETTING] → [BRIGHTNESS]
[NETWORK]
Congure the settings to use the network function.
r Setting the wired LAN IP version
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select [NETWORK].
4) Press the <ENTER> button.
f The network selection item is displayed.
5) Press as to select [WIRED LAN].
6) Press the <ENTER> button.
f The IP setting item is displayed.
7) Press as to select [IP VERSION].
8) Press the <ENTER> button.
f The current setting is displayed.
9) Press the <ENTER> button.
f Setting can be changed.
10) Press qw to switch the setting.
f The items will switch each time you press the button.
[IPv4] Uses only the “IPv4” protocol.
[IPv6] Uses only the “IPv6” protocol.
[IPv4 & IPv6] Both the “IPv4” and the “IPv6” protocols can be used.
Note
f This setting item is common with the following menu item in the on-screen menu.
g The [NETWORK] menu → [WIRED LAN] → [IP VERSION]
r Setting the acquisition method of the wired LAN IPv4 address
1) Press as to select [SETUP].
2) Press the <ENTER> button.
f The sub-menu item is displayed.
3) Press as to select [NETWORK].
4) Press the <ENTER> button.
f The network selection item is displayed.
5) Press as to select [WIRED LAN].
6) Press the <ENTER> button.
f The IP setting item is displayed.
To Next Page
Loading...
