Panasonic PT-RQ25K Series

Chapter 5 Operations — Updating the rmware
ENGLISH - 297
8) Enter a security password and press the <ENTER> button.
f The [FIRMWARE UPDATE] screen is displayed.
9) Press qw to select [OK], and press the <ENTER> button.
f Update is started.
f The projector goes into the standby mode once the update is started, and the light source indicator
<LIGHT> and the temperature indicator <TEMP> blink in red alternately.
10) Confirm the firmware version.
f Update is completed when the light source indicator <LIGHT> and the temperature indicator <TEMP> stop
blinking and turn off.
f Turn on the power of the projector and conrm the rmware version in the [STATUS] screen.
Attention
f Do not disconnect the main power supply of the projector while updating.
Note
f If the update does not complete after 60 minutes or more have elapsed, turn the power of the projector off and on and perform the update
from the beginning.
f If the power of the projector is turned off by a power outage or other reason during the update, the update is automatically restarted after the
power outage is restored or right after the power of the projector is turned on again.
Operating the information monitor to update the rmware
Rewriting of the rmware can be performed by operating the information monitor even if the projector is in the
standby mode.
1) Insert the USB memory with the firmware data saved into the <USB> terminal of the projector.
2) Confirm that the projector is in the standby mode.
3) Press the <INFO> button on the control panel.
f The top menu screen is displayed.
4) Press as to select [SETUP].
5) Press the <ENTER> button.
f The sub-menu item is displayed.
6) Press as to select [PROJECTOR].
7) Press the <ENTER> button.
f The detailed item is displayed.
8) Press as to select [FIRMWARE UPDATE].
9) Press the <ENTER> button.
f The security password entry screen is displayed.
10) Enter a security password and press the <ENTER> button.
f The rmware update execution conrmation screen is displayed.
f The rmware version after the update can be conrmed by pressing w while the execution conrmation
screen is displayed.
g Press q while the rmware version is displayed to return to the execution conrmation screen.
11) Press the <ENTER> button.
f Update is started.
f Rough progress can be conrmed in the information monitor once the update is started.
f The light source indicator <LIGHT> and the temperature indicator <TEMP> blink in red alternately while
updating.
f Update is completed once [FIRMWARE UPDATE COMPLETE] is displayed in the information monitor.
Attention
f Do not disconnect the main power supply of the projector while updating.