Panasonic PT-RQ25K Series - Page 310

Chapter 7 Appendix — Technical information
310 - ENGLISH
Control details
Art-Net channel setting
[1] [2] [3] [USER]
LENS H SHIFT LSB ― ― ―
l
*1
LENS V SHIFT MSB ― ― ―
l
*1
LENS V SHIFT LSB ― ― ―
l
*1
LENS FOCUS MSB ― ―
l l
*1
LENS FOCUS LSB ― ―
l l
*1
LENS ZOOM MSB ― ―
l l
*1
LENS ZOOM LSB ― ―
l l
*1
ENABLE/DISABLE
l l l l
*1 These items can be controlled in following case.
When the standard DC motor unit installed in the Zoom Lens (Model No.: ET-D75LE6, ET-D75LE8, ET-D75LE10, ET-D75LE20, ET-D75LE30,
ET-D75LE40) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET-D75MKS10), or when a projection lens with the
stepping motor is attached.
Control details
r LIGHT OUTPUT
This can be set in 256 steps between 100 % and 0 %.
Performance Parameter Default value
100 % 0
0… …
0 % 255
r INPUT SELECT (when [Art-Net CHANNEL SETTING] is set to [1])
Performance Parameter Default value
No operation 0-39
0HDMI1 40-47
No operation 48-255
r INPUT SELECT (when [Art-Net CHANNEL SETTING] is set to anything other than [1])
Performance Parameter Default value
No operation 0-31
0
HDMI1 32-39
HDMI2 40-47
DisplayPort 48-55
No operation 56-79
SLOT
*1
80-87
No operation 88-255
*1 Switches the input to SDI, DIGITAL LINK, PressIT, or SLOT.
SDI: When the optional 12G-SDI Terminal Board (Model No.: TY-SB01QS) is installed in <SLOT>
DIGITAL LINK: When the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) is installed in <SLOT>
PressIT: When the optional Wireless Presentation System Receiver Board (Model No.: TY-SB01WP) is installed in <SLOT>
SLOT: When the Function Board by other manufacturers is installed in <SLOT>