Panasonic PT-RQ25K Series

Chapter 1 Preparation — About your projector
36 - ENGLISH
r Connecting terminals
13
321 6
4 5 7
108 9 11 12 14
1 <MULTI SYNC IN> terminal/<3D SYNC 1 IN/OUT> terminal
(dual purpose)
This terminal is used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
This terminal is also used to input or output control signals
when using the projector in 3D systems.
(PT-RZ24K and PT-RZ17K only)
2 <MULTI SYNC OUT> terminal/<3D SYNC 2 OUT> terminal
(dual purpose)
This terminal is used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
This terminal is also used to output control signals when using
the projector in 3D systems.
(PT-RZ24K and PT-RZ17K only)
3 <MULTI SYNC IN> terminal/<MULTI SYNC OUT> terminal
This terminal is used to connect multiple projectors when
balancing the contrast as a combined screen or synchronizing
the effects using the shutter function including the fade in/fade
out with a system using multiple projectors.
(PT-RQ25K and PT-RQ18K only)
4 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally control
the projector by connecting a computer.
5 <SERIAL OUT> terminal
This is a terminal to output the signal connected to the <SERIAL
IN> terminal.
6 <REMOTE 1 IN> terminal/<REMOTE 1 OUT> terminal
These are terminals to connect the remote control for serial
control in a multiple projector environment. (x page 40)
7 <REMOTE 2 IN> terminal
This is a terminal to remotely control the projector using the
external control circuit.
8 Slot (<SLOT>)
There is an Intel
®
Smart Display Module (Intel
®
SDM)
specication slot internally. Function Board supporting the Intel
®
SDM Small (Intel
®
SDM-S) or the Intel
®
SDM Large (Intel
®
SDM-L) specication can be installed. (x page 61)
9 Slot cover
10 <USB> terminal
This is a terminal to connect the USB memory when using the
data cloning function or rmware update function. (x pages
287, 291)
This is also the terminal to connect the optional Wireless
Module (Model No.: AJ-WM50 Series) when the projector is
connected via wireless LAN. (x page 236)
11 <DC OUT> terminal
This is the USB terminal dedicated for power supply. (DC 5 V,
2 A)
Use this terminal when a power supply is required to wireless
display adapters and wireless LAN/Ethernet converters, etc.
12 <LAN> terminal
This is the LAN terminal to connect to the network.
13 <HDMI IN 1> terminal/<HDMI IN 2> terminal
These are terminals to input HDMI signal.
14 <DisplayPort IN> terminal
This is a terminal to input DisplayPort signal.
Note
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
f When connecting a USB memory to the <USB> terminal, also refer to “Using the USB memory” (x page 96).
f When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [NORMAL], power can be supplied by using the <DC OUT> terminal
even while the projector is in standby mode. If [ECO] is set, power cannot be supplied in standby mode.