Parker Hannifin Manufacturing Srl user’s manual TPDM
4.3 Mounting instructions
Do not install in hazardous environments.
Fasten the drive in the cabinet using the reamed holes on the mounting plate (see illustration).
• FIT IN VERTICAL POSITION.
• To ensure drive cooling, leave a free space above, below and in front of at least 100
mm. The illustration shows how hot air cooling must be done in an external
environment, to avoid damage caused by the formation of condensation.
• The flow of air entering the converter must not come from or pass through other
heat source parts.
• Fit a suitable ventilation filter inside the switchboard.
Measurements expressed in mm. Tolerance ±1.5 mm.
To Next Page
Loading...
