Parker TPDM - Identification

Parker Hannifin Manufacturing Srl user’s manual TPDM
13
2.3 Identification
The converters of the TPD series are available in different models (see par. “models available”). The
number that follows the TPD abbreviation corresponds to the rated current of the converter in
amperes.
Use the following table to specify the order code:
TPDM
A1
A2
A3
B1
C1
D1
E1
F1
G1
Where :
TPDM
servodrive series
A1
drive size axis A (nominal current: 2, 5, 8… A)
See par.
“available models”
A2
drive size axis B (nominal current: 2, 5, 8… A)
A3
drive size axis C (nominal current: 2, 5, 8… A)
B1
Field bus
C1
FBK sensor device
D1
Optional board
E1
Safety option
F1
Accessories
G1
Hardware version
A label attached on the right side (*) of the converter contains all the essential information to
correctly identify the unit:
Serial number
Model
Nominal plate data
It is important to refer to this label before requesting any kind of technical information to Parker
Hannifin Manufacturing Srl
(*) on the internal side of the protective cover, there is a label that shows the Model and the Serial
Number. Pay attention, before opening the protective cover, wait 5 minutes after have disconnected
the mains supply.