Parker TPDM - Page 44

Parker Hannifin Manufacturing Srl user’s manual TPDM
43
Hold M pressed for 2 sec. while the name of a parameter (PRxx) is displayed to make the keypad
control switch to a different axis; a led will denote the active axis (A, B or C).
The following messages may be displayed on the screen, in addition to the value of the parameters
and the instructions of the pico-PLC:
Pr. Xx Indicates the parameter xx whose value can be displayed by pressing the [M] key.
Pb. Xx Indicates the parameter at bit xx.
bxx.yy Indicates the bit yy of parameter xx. By pressing the [M] key, the status of the bit is
displayed.
In. xx Indicates instruction xx of the PLC program.
donE Is displayed for about 1 second whenever a command is sent.
rESet Is displayed for about 1 second whenever an alarm reset command is sent (b99.10).
triP.x Indicates that the converter has malfunctioned.
If you cannot modify the read-write parameters using the keypad, be sure that b99.7 is 0; is it
was 0, probably the same parameters were modified by the pico-PLC program.
Pr...
Pb...
In...
+
-
+
-
+
-
0
M
M +1
-1 M
M
-
+ +9
-9
b39
.
x
M
M
0
M
M
1
0-
+
dOnE
PLC inst
M M
-
+
-
+
1
st
oper
.
M
-
+
2
nd
oper.
M
-
+
3
rd
oper.
M
-
+
LoAd
Pico-
PLC
status
+
-
SD card
(b99.6=1)