Pairing ANAFI USA to a Skycontroller 3
Follow this procedure to pair a drone and a controller for the first time, and to restore the lost pairing
between a drone and a controller.
1. Verify that a compatible microSD card is inserted into ANAFI U SA.
2. Press Power on ANAFI USA.
3. Open the Skycontroller 3 to power it on.
4. Connect the drone and the controller with a USB cable (USB-A connection to the controller,
USB-C connection to the drone).
5. The LED of the Skycontroller 3 briefly flashes green to indicate it acknowledges ANAFI USA.
6. Wait for synchronization between Skycontroller 3 and ANAFI USA (steady dark blue LED on
the controller): Verify that the left trigger of the Skycontroller 3 activates the drone’s gimbal
to ensure the synchronization is complete.
7. Disconnect the controller from the drone.
To Next Page
Loading...
