Reboot all systems
Rebooting all systems can solve connectivity issues (black screen, white noise, etc.).
1. Press Power to power off ANAFI USA.
2. Close the FreeFlight 6 USA application on your Skycontroller.
3. Reboot your Skycontroller.
Press Power to power on ANAFI USA.
4. Wait for synchronization between Skycontroller and ANAFI USA: check that the left trigger
of the Skycontroller activates the drone’s gimbal to ensure the synchronization is complete.
Issues
What do I do if I experience a connectivity issue (black screen, white noise, thermography
camera activation failure, frozen or lagging stream)?
1. Check that your device’s Wi-Fi is disabled: Parrot recommends you set your device in Airplane
mode when you fly ANAFI USA, to minimize the risks of communication disturbance.
2. Reboot all systems (refer to the relevant procedure in the earlier section of this guide).
What do I do if my ANAFI USA’s gimbal does not calibrate?
Hard reset ANAFI USA (refer to the relevant procedure in the earlier section of this guide).
What do I do if my ANAFI USA does not power on?
Ensure that your smart battery is “awake”. Plug it into a power source to take it out of wintering mode.
Its LED should start flashing to acknowledge that it is charging. Parrot recommends you always fully
charge your smart battery before you fly ANAFI USA.
What do I do if my battery shows a strange behavior (flashing LED, red LED, etc.)?
Reset the smart battery (refer to the relevant procedure in the earlier section of this document).
What do I do if I cannot properly read the information displayed by FreeFlight 6 USA?
1. Access the settings of your device.
2. Find the Display / Text and display size (or equivalent) options.
3. Turn down the text size of your device, its display size, or both to let FreeFlight 6 USA
accommodate all its information on your screen.
What do I do if my ANAFI USA is connected to the Skycontroller, but won’t take off when I hit
the take-off button?
1. Connect your device (in airplane mode, or with Wi-Fi turned off) to your Skycontroller.
2. The drone or controller boxes of the homepage of FreeFlight 6 USA indicate either that:
- you must update your Skycontroller, your ANAFI USA, or both;
- or you must calibrate your ANAFI USA’s gimbal;
- or you must carry out a magnetometer (drone) calibration;
- or you must calibrate your Skycontroller.
What do I do if my ANAFI USA flips over at take-off?
The propeller blades have been improperly installed. Remove all propeller blades and reinstall them
properly and carefully, following the instructions enclosed in all ANAFI USA propeller blades packs.
To Next Page
Loading...
