38
Smart LiPo Battery
One smart battery comes preinstalled on the ANAFI USA. You can charge the smart battery when
installed on ANAFI USA, or when removed from ANAFI USA. If you remove the battery, you must
reinstall it in the same orientation. Ensure that you do not install the battery upside down as it can
expose the battery and the drone to irreparable electrical damage. Always use genuine Parrot smart
batteries. Non-genuine batteries are forbidden, and their use will void the warranty and impact safety
requirements.
Important: The LEDs and Power button face up in the correct orientation.
Important: Do not apply pressure or touch the drone’s gimbal when you handle ANAFI USA
Note: LiPo batteries gradually lose capacity after 300 charge/discharge cycles.
Battery removal
To remove the smart battery from the drone, unfold the rear arms of ANAFI US A. Set the drone on
a flat and even surface and press the push-button which connects the battery to the body of the drone
with your thumb. Gently slide your thumb and the battery toward the back of ANAFI U SA. When the
hook of the push-button is disengaged from the body of the drone, lift the battery away from
ANAFI U SA.
Battery installation
To install the smart battery on the drone, unfold the rear arms of ANAFI USA. Set the drone on a flat
and even surface and position the battery’s three hooks into the drone’s corresponding slots. Place
your middle finger on the Parrot logo of ANAFI USA and your thumb on the back of the smart battery.
Squeeze your fingers together until you feel and hear the battery clicking into the body of the drone.
Battery charging
To charge the smart LiPo battery, use the enclosed USB-A to USB-C cable to connect the battery to its
enclosed charger. Alternatively, this cable enables you to charge the battery from:
- a tabletop or laptop computer’s USB-A port.
- a power bank’s USB-A port.
ANAFI U SA’s smart battery can also be recharged through a Power Delivery adapter or charger (USB-
PD standard), using a USB-C to USB-C cable (not included in the box). In that configuration, full charging
time of the battery can be reduced to 115 minutes.
Important: Parrot does not recommend ANAFI USA users to invest in a USB-PD power bank, as not
all of them support USB-C to USB-C charging of ANAFI USA’s battery. Due to the nature of the USB-
C technology, some USB-PD power banks recharge on ANAFI USA’s smart battery, rather than the
other way around.
Warning: Other generic USB chargers may be used provided that they are certified according to the
country of use, and have the applicable rating/specification. Performance and warranty are only
guaranteed when using the genuine charger included in the Parrot drone system.
To Next Page
Loading...
