Appendix 2: Operational checklist
Useful information
This checklist has been developed with military ANAFI series drone pilots. It provides useful
information to every ANAFI USA pilot.
Update & calibration
Device SYSTEMATICALLY UP TO DATE
FreeFlight 6 USA SYSTEMATICALLY UP TO DATE
Skycontroller SYSTEMATICALLY UP TO DATE
ANAFI USA SYSTEMATICALLY UP TO DATE
Magneto calibration OK
Skycontroller calibration OK
Gimbal calibration OK
Important: Parrot strongly recommends that you regularly refer to the Release Notes ANAFI USA
available on the Parrot website, to ensure that you have the latest versions of the drone and controller
firmware, and FreeFlight 6 USA App. If you are an offline user, you must contact your local Parrot
Partner or Parrot Contact to obtain the .apk file to perform an offline system update. Refer to the
“FreeFlight 6 USA offline update via APK file (Android users)” chapter for more information.
Skycontroller & ANAFI USA OFF
Arms unfolded, locked
Arms mechanical lash NONE
Lens cap OFF
Check drone and gimbal OK
Check propellers intact, free
Check Skycontroller OK, 100 % charged
Check terminal to Skycontroller cable OK
ANAFI U SA battery OK, 100% charged
ANAFI U SA battery LED 4 x OK
ANAFI U SA battery temp OK
Device OK, 100% charged
MicroSD card Inserted
ANAFI U SA battery 3 hooks engaged in drone, locked
Skycontroller & ANAFI USA ON
Skycontroller open, ON, flashing light to dark blue LED
ANAFI U SA ON, gimbal calibration OK
SC3 / ANAFI USA Wi-Fi connection steady dark blue LED on SC3,
L trigger moves gimbal: OK
Device ON, Wi-Fi & Bluetooth OFF
Device / SC3 link FreeFlight 6 USA launched,
Image feed & telemetry: OK
Flight mode selection MANUAL
RTH Height set (20m to 100m)
Max altitude set
Max distance set
Geocage activated if needed
Image settings OK
Check Stick Mode Inverted / Special mode
Map on app OK
To Next Page
Loading...
