152
Shooting Functions
4
5
Press the shutter release button halfway.
The autofocus system operates. The focus indicator ] appears in the
viewfinder when focused.
6
Press the shutter release button fully.
Pictures are taken continuously while the shutter release button is fully
pressed. Take your finger off the shutter release button to stop.
During Interval Shooting, pictures are taken at a set interval from a set
time.
1
Select [Interval Shooting] in the [A Rec. Mode 2] menu
and press the four-way controller (5).
The [Interval Shooting] screen appears.
• If the focus mode is set to l (Single mode), the focus position is locked in
the first frame and pictures are taken continuously at the same interval.
• Focusing is continuously activated during Continuous Shooting when the focus
mode is set to k (Continuous mode).
• You can also use the remote control for Continuous Shooting. (p.145)
• The shutter cannot be released until charging is complete when using the
built-in flash. You can set the camera to enable shutter release before the
built-in flash is ready in [20. Release While Charging] of the [A Custom
Setting 3] menu. (p.82)
• Select a mode other than g or h in the [Drive Mode] screen to cancel the
Continuous Shooting. The setting is canceled when the camera is turned off
if [Drive Mode] is set to P (Off) in [Memory] (p.312) of the [A Rec. Mode 5]
menu.
• The shooting speed may be slower when [Lens Correction] (p.218) is set to
On.
Interval Shooting
• Interval Shooting is not available in the following situations.
- when the exposure mode is set to A, B (Green), p (Bulb), or C
(Movie)
- when Extended Bracketing, Digital Filter or HDR Capture is set
• When Interval Shooting is set, Multi-exposure is not available.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
