77
Basic Operations
3
Using the Built-in Flash
Use the following procedures to take pictures in low light or backlit
conditions and when you want to use the built-in flash.
The built-in flash is optimum for a subject at a distance from 0.7 m to 5 m.
Exposure will not be properly controlled and vignetting (darkening of the
corners of the image due to a lack of light) may occur when used at a
distance closer than 0.7 m (this distance varies slightly depending on the
lens being used and set sensitivity. (p.185))
For details on the built-in flash and instructions on how to take pictures with an
external flash, refer to “Using the Flash” (p.181).
Setting the Flash Mode
Flash Mode Function
C
Auto Flash
Discharge
Discharges the flash automatically in dark or backlit
conditions.
D
Auto Flash+
Red-eye Reduction
Discharges a pre-flash for red-eye reduction before
the automatic flash.
E
Flash On Discharges the flash for each picture.
F
Flash On+
Red-eye Reduction
Discharges a pre-flash for red-eye reduction before
the main flash.
Compatibility of built-in flash and lens
Vignetting may occur depending on the lens being used and the
capture conditions. We recommend taking a test shot to check the
compatibility.
1 Lens Compatibility with the Built-in Flash (p.186)
• When using the built-in flash, remove the lens hood before shooting.
• The built-in flash fully discharges for lenses without a function to set the
lens aperture ring to s (Auto).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
