15192 Triton Lane
Huntington Beach, CA 92649
Office Tel: 714-892-3400
Hotline Tel: 714-891-6533
www.ppedm.com
This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
C)
When using a CG system, using a small drill bit, clean out the hex hole if
one exists. There is no need to remove metal – simply remove any loose
debris or coatings inside the hole such that good electrical conductivity will
occur.
D)
In order to ensure longevity of the O-ring inside the collar adapter it is good
practice to grease the inside of the collar adapter or the outside of the collar.
Push the E-Drill Adapter lightly over the collar, completely enclosing it. Allow
the Adapter to determine the concentricity and alignment of the hand-tool.
Press down to make a seal and squeeze the trigger.
To Next Page
Loading...
