This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
6.0
APPENDIX 3. Trouble-Shooting Guide
This section of the User Guide lists common maintenance issues encountered and their
solutions. It is recommended that the following basic steps be accomplished before
proceeding to a higher level of trouble shooting.
To avoid problems critical maintenance items which should be checked before each shift:
o
Check for free movement of hand-tool motion over full stroke.
o
Tighten electrode using Electrode Torque Wrench.
o
For Center Ground hand-tool check Ground Pin for proper protrusion, insulation and
straightness. (Does not apply to EG Hand-tool.)
o
For External Ground hand-tool check the Ground clamp and bullet connector
condition.
In the event these basic steps do not remedy the issue, review the Troubleshooting Guide for
helpful maintenance remedies.
If a solution cannot be found in this Trouble-Shooting Guide, do not hesitate to contact the
Customer Service Hotline Phone at 714-891-6533. This number is located in 3 places on the
system for ease of access.
1.
Mobile Service Unit directly above the system power switch.
2.
The “Information” page of the “Maintenance” screen in the Hand Held
Terminal software.
3.
Printed in the header of this User Guide.
To Next Page
Loading...
