This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
5.5
Vacuum Flush Head Locator System:
The VFHL System is specifically developed for removing flush head fasteners from
composite structure where cut accuracy is more critical than standard applications.
The VFHL system is the only tool recommended for use to remove flush fasteners
from composite structures.
The VFHL System is a completely self contained system that operates on standard
100 to 150 psi
regulated shop air
pressure. The system
comes with a 3 suction
cup Locator and
special set of VFHL E-
Drill Adapters and
Locators that uses
standard Electrode
Guides for centering
the Electrodes.
The Vacuum Flush
Head Locator will
operate on both
convex and concave
curved surfaces down
to a radius of
approximately 4 ft, and
on fasteners greater
than 2” from the edge of a panel. In situations with radius less than that (wing leading
edge or lip seal leading edge as examples) or where fasteners are located on the
edge of a panel, an alternative means of location might be more suitable.
5.6
Accessories - S-Blaster, Punches, Drill stands and Holsters, Toolboxes etc.
Perfect Point is continually adding accessories to the E-Drill product line, based on
customer feedback. Please visit the PPEDM web site (www.ppedm.com) or ask your
E-Drill representative for the current list of available accessories.
5.7
Custom Adapters and tooling
Custom made and specialty tools are also available from Perfect Point EDM Inc. for
difficult, hard to reach fastener locations, fastener specific kits, pilot drilling or seized
bolt removal. Contact the Customer Service number at (714-891-6533) for details
about special or custom designed tooling.
To Next Page
Loading...