15192 Triton Lane
Huntington Beach, CA 92649
Office Tel: 714-892-3400
Hotline Tel: 714-891-6533
www.ppedm.com
This document is the property of PPedm Corp. and contains proprietary and/or patented information and may not be reproduced in
part or in whole without the express written permission of the company. Perfect Point logo, Perfect Point
TM
and E-Drill
®
are
trademarks of PPedm, Corp. US and worldwide patents pending.
5.
Allow the E-Drill to reach its own perpendicularity to the fastener as influenced
by the E-Drill Adapter and its seal, and then wrap the fingers around the grip
to hold securely during cutting.
6.
Depress the trigger on the E-Drill and keep the trigger depressed until the
process is completed, as indicated by the status light on the back of the
hand-tool illuminating green.
7.
Hold the hand-tool as steady as possible during the cutting process.
8.
Hold the E-Drill over the fastener for a second with the trigger depressed
allowing the vacuum system to suck up any excess water left behind by the
process. The vacuum will continue to operate for as long as the trigger is
depressed.
To Next Page
Loading...
