Philips Efficia DFM100 - Page 166

14: Configuration Overview
154
Table 37 Waves Settings
Parameter Description Setting Choices User Setting
 Selects the waveform displayed in Wave Sector 1. , , , , , , , 
NOTE: The default for Wave Sector 1 cannot be set to paddles.
 Selects the waveform displayed in Wave Sector 2. , , , , , ,
, , , 

, , , 

Selects the waveform displayed in Wave Sector 3. , , , , , ,
, , , , .
Default: CO2 if you have the
EtCO
2
option; Pleth if you
have the SpO
2
option but not
the EtCO
2
option; None if you
do not have either option.
Table 38 Defib Sync Settings
Parameter Description Setting Choices User Setting


Defines the device’s low-energy setting. 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 J



Defines if the device remains in Sync Mode after
a delivered shock.
, 


Defines the amount of time the device remains
charged if a shock has not been delivered. Applies
to Manual Defibrillation and Sync modes only.
30, 60, 90 

Defines the number of shocks in a shock series. 1, 2, 3, 4


Defines the time interval used to determine if a
shock should be counted as part of a shock series.
, , 
Table 39 AED Settings
Parameter Description Setting Choices User Setting
 Defines the level of detail in AED Mode voice
prompts.
, 
 Defines what the device does after a No Shock
Advised decision.
, 
(NSA Monitor allows you to initiate
background shock advisory analysis;
NSA CPR prompts you to initiate a
CPR Pause period, if needed.)


Defines the interval for patient care prompts in
NSA Monitor following a No Shock Advised
decision.
1, 2, 3,  (no prompts
at all) min