The WDS mode in client mode may only be activated if you are sure that
your access point also supports this mode. Otherwise you will no longer
be able to reach the device via WiFi.
If you have selected the Client mode in the WLAN settings, you have the
option in the subgroup “WLAN AP settings” to configure an additional
WLAN network that works in access point mode:
Deactivate WLAN AP: Indicates whether the WLAN AP is disabled
shall be.
DHCP mode: - The device is via the
address set can be reached.
Client The device obtains an IP
Address from a DHCP Server.
server The device is via the
address set can be reached
and provides other devices with
IP Addresses available.
IP address: The IP address of the device.
Subnet mask: The subnet mask of the device.
Gateway: The IP address of the gateway (optional).
DNS server: The IP address of the DNS server (optional).
(DHCP mode, IP address, subnet mask,
Gateway and DNS server not included
CONNECT CONTROL)
SSID: The SSID / name of the WLAN network.
Security_level: The security level/encryption of the
WiFi network.
Page 65 Handbook CONNECT / CONNECT-II / CONNECT-CONTROL V1.13
To Next Page
Loading...
Need help?
General