Pitco SSH Series - Removing the Solid State Wiring Harness

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 21
RemovingtheSolidStateWiringHarness
1. Remove the two (2) screws in the front panel
bottom holder using a 5/16 inch socket.
2. Remove the two (2) screws in the cable retainer
bracket using a 5/16 inch socket.
3. Disconnect the probe connection (J/P43).
4. Disconnect B6746601 from J/P33 on the relay
board.