Pitco SSH Series - Pitco mV Fryer Servicing Access; Pitco mV Gas Valve Vent Tube Cleaning; Pitco mV Burner Manifold Gas Pressure

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 51
AccessingFryerforServicing
1. Shut off the main gas supply line.
2. Shut off the individual gas supply line.
CleaningtheGasValveVentTube
See “Cleaning the Gas Valve Vent Tube” on page 13.
CheckingtheBurnerManifoldGasPressure
TakinganIncomingSupplyGasPressureReading
4. Connect the manomet
er.
1. Unscrew and remove the gas supply plu
g with a
3/16 inch hex wrench.
5. Turn on the main gas supply
line.
2. Finger tighten the test fitting int
o the test port.
3. Finish tightening the test fitting using a 7/16
inch open-ended wrench.