Pitco SSH Series - Pitco Burner Manifold Gas Pressure Check; Pitco Supply Gas Pressure Reading

PitcoSolsticeandSolsticeSupremeHighEfficiencyGasFryers



SG/SSHSeriesServiceManual 14
CheckingtheBurnerManifoldGasPressure
TakingaSupplyGasPressureReading
1. Unscrew and remove the gas supply plug with a
3/16 inch hex wrench.
2. Finger tighten the test fitting into the test port.
3. Finish tightening the test fitting using a 7/16
inch open-ended wrench.
4. Connect the manometer.