5-66 DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
5 • Removal and Replacement
DA95F (WF96) - Printer Parts Removal
5.36 Print
Head Cables
and Print
Head Boards
(continued)
23. Reassemble covers and parts as needed.
IMPORTANT! Keep in mind the following points when reassembling:
• Attach the correct end of the ribbon cable to the print head board and
the correct end to the main board. Failure to do so can blow out
the print head board, the main board, or both!
• Be careful when reconnecting the ribbon print head cables (J1 to
J6) at the main processor board and at the print head side. Make
sure each cable is aligned straight before fully seating; otherwise,
some pins may touch and cause damage to the print head (Newport)
boards upon powering up.
• If, during this procedure, you removed the print head assembly from
the print head shaft as in step 8 (not just the print head board), you
need to perform the Leveling the Print Head Assembly to Deck ad-
justment (see section 6.6). If you did not remove the print head as-
sembly but merely removed the print head board, you do not have to
perform the Leveling the Print Head Assembly to Deck adjustment.
24. Power up the machine. Do a print test from the control panel to confirm
proper operation of print heads.
To Next Page
Loading...
