A-28 DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Appendix A • Printer Control Panel Menus and Utilities
Setup Menu
Parameter Default Setting
1. Stop on Feed Error On
2. Feeder Setup Feeder Type Standard Feeder
Feeder Signal None
Mode Normal Off
Signal Polarity Active On
Pulse Time (msec) 10
3. Conveyor Setup Use Conveyor Disable
Conveyor Type Stacker
Activate Polarity Rising Edge
Conveyor on time 0.1
4. Lines per address 8
5. Communications TCP/IP DHCP enabled,
IP Address/Sub-
net Mask/Gateway
000.000.000.000,
Port Number 5100
Line Termination CR=CR LF=LF
6. Language Symbol Set ISO 6 ANSI ASCII
Inch/Millimeter Inch
Menu Language English
7. Transport Speed 100% of max.
8. Feed Gap Feed Gap Type Stream Feeding
Feed Gap Distance 1.50 in
9. Ink Cartridge Volume Normal Capacity
10. Pre-Purge Purge at Start Disable
Periodic Purge Disable
Purge Interval 120 seconds
Nozzle Keep Alive Enable
11. Bundle Break Enable/Disable Disable Bundle Break
Break Character #
Character Orientation Vertical
Break Location After Address
Print Break Characters Disable
Break Pause Time 3.00 seconds
A.6 Setting
Factory
Defaults (from
LCD Menu)
✍
TIP: Only parameters
that have default set-
tings are listed.
To Next Page
Loading...
