5-26 DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
5 • Removal and Replacement
DA80F (WF81) Parts Removal
5.15 Print
Head Cables
and Boards
(continued)
16. Attach (new) print head ribbon cables, starting at print head side. Apply a
light push to the cable while inserting to allow it to seat fully and straight
into the connector socket. Make sure the cable end is marked "PH" for
print head, and the black tab at the cable end is pointing upwards as it is
being inserted into the print head connector. After inserting cable, press the
tan locking piece inwards (toward the connector) to lock cable into place.
Tan Locking Piece Edge of
Connector
Black Tab Facing Up
17. Route the three print head ribbon cables through metal print head cover
and clamping mechanism (has tape on one side) and fasten clamp with
cables to print head assembly (one screw). Make sure there is enough
slack (see figure) when in final position.
Metal Clamp for
Print Head Cables
18. Re-attach print head metal cover (four screws, small allen size).
19. Route new cables through black stiffener saved from the original print
head cables and clamp above main board. Use the two screws to clamp
down on the cable stiffener.
Clamp for Print Head Ribbon Cable
Stiffener (Screws Circled)
To Next Page
Loading...
