User Manual of WDAP-C7200AC/WDAP-W7200AC
-91-
Figure 5-72 WDS – Set Security
The page includes the following fields:
Object Description
Enable WDS Check the box to enable the WDS function. Please select WDS or
AP+WDS in the Mode of Wireless Basic Settings before you enable
WDS on this page.
MAC Address You can enter the MAC address of the AP you want to connect with.
Data Rate Default is “Auto”.
Comment You can make some comment for each MAC address on the list.
Set Security Click “Set Security” to configure the wireless security parameters of the
AP you want to connect via WDS.
Show Statics Click “Show Statics” to show the WDS AP.
Current WDS AP List You can select some MAC addresses of the AP and click “Delete
Selected” to delete it.
WDS feature can only be implemented between 2 wireless devices that both support the
WDS feature. Plus, channel, security settings and security key must be the same on
both such devices.
To encrypt your wireless network, click “Set Security”. For the detail of wireless security,
see section 5.5.4
. Do remember to reboot the device after you save your wireless
security settings; otherwise, the WDS feature may not function.
To Next Page
Loading...
Need help?
General
