User Manual of WDAP-C7200AC/WDAP-W7200AC
-75-
SSID” can provide better wireless network security.
Default is “Enabled”.
Data Rate
Set the wireless data transfer rate to a certain value. Since most of
wireless devices will negotiate with each other and pick a proper data
transfer rate automatically, it’s not necessary to change this value
unless you know what will happen after modification.
Default is “Auto”.
Enable Mac Clone
(Single Ethernet Client)
Enable Mac Clone.
Example of how to configure Client Mode. Please take the following steps:
To configure each wireless parameter, please go to the “WLAN2 (2.4GHz) → Basic Settings” page.
Step 1. Go to the “WLAN2 (2.4GHz) → Site Survey” page and click “Site Survey”.
Figure 5-59 Client – Survey
To Next Page
Loading...
Need help?
General
