User Manual of WDAP-C7200AC/WDAP-W7200AC
-52-
SSID” can provide better wireless network security.
Default is “Enabled”.
Data Rate
Set the wireless data transfer rate to a certain value. Since most of
wireless devices will negotiate with each other and pick a proper data
transfer rate automatically, it’s not necessary to change this value
unless you know what will happen after modification.
Default is “Auto”.
Associated Clients
Click “Show Active Clients” to show the status table of active wireless
clients.
Enable Universal
Repeater Mode
(Acting as AP and client
simultaneously)
Universal Repeater is a technology used to extend wireless coverage.
To enable Universal Repeater mode, check the box and enter the
SSID you want to broadcast in the field below. Then please click
“Security” in the submenu for the related settings of the AP you want to
connect with.
5.4.2 Advanced Settings
Choose menu “WLAN1 (5GHz) Advanced Settings” and you can configure the 5GHz advanced settings for
the wireless network on this page. After the configuration, please click “Apply” to save the settings.
Figure 5-34 Wireless Advanced Settings – 5GHz
The page includes the following fields:
To Next Page
Loading...
Need help?
General
