User Manual of WDAP-C7200AC/WDAP-W7200AC
-40-
The device supports up to four multiple Service Set Identifiers. You can go back to the Basic Settings page
to set the Primary SSID. The SSID’s factory default setting is Planet 5G VAP1~4 (Multiple-SSID 1~4). The
SSID can be easily changed to connect to an existing wireless network or to establish a new wireless
network. When the information for the new SSID is finished, click Apply Changes to let your changes take
effect.
Figure 5-21 5GHz Multiple-SSID
Once you have applied and saved those settings, you can then go to the “WLAN1 (5GHz) → Security”
page on the AP to set up security settings for each of the SSIDs.
Universal Repeater
This mode allows the AP with its own BSS to relay data to a root AP to which it is associated with WDS
disabled. The wireless repeater relays signal between its stations and the root AP for greater wireless
range.
1. Example of how to configure Universal Repeater Mode. Please take the following steps:
To configure each wireless parameter, please go to the “WLAN1 (5GHz) → Basic Settings” page.
Step 1. Configure wireless mode to “AP” and then check “Enable Universal Repeater Mode (Acting as AP
Step 1. Configure wireless mode to “AP” and then check “Enable Universal Repeater Mode (Acting as AP
2.4G
5G
Clients
Smart Phone
Switch
WDAP-C7200AC
AP
Universal Repeater Mode
Internet
g/n
g/n
a/n/ac
a/n/ac
To Next Page
Loading...
Need help?
General
