Plockmatic SR 85 - REP 2.6 Back jogger motor MOT 7

Bookletmaker SR 85 February 2001PAGE
REMOVAL
1. Switch off the main power and disconnect the power cord.
2. Remove the infeed module according to REP 2.1.
3. Disconnect the ground wire (1).
4. Loosen the setscrew in the collar (3).
5. Remove the motor (2).
INSTALLATION
1. Install the motor.
2. Ensure that the pin on the motor is inserted in the grommet (4).
3. Push the collar (5) of the flange bushing firmly against the bracket.
4. Tighten the setscrew (3) on the flat of the shaft.
5. Connect the ground wire (1).
6. Install the infeed module according to REP 2.1.
7. Check/adjust the Staple/fold position according to REP 5.2.
REP 2.6 Back jogger motor MOT 7
2.6.1
12 3
45