Bookletmaker SR 85 February 2001PAGE
REMOVAL
1. Switch off the main power switch and disconnect the power cord.
2. Remove the Infeed module according to REP 2.1
3. Remove the four screws (1).
4. Slide the drive coupling (5) off of the drive shaft (4) and remove the transport belt as-
sembly.
5. Remove the belt (2) from the assembly.
INSTALLATION
Installation is an exact reversed procedure of removal.
Note: Make sure the flat side on the bearing (3) is up when installing.
REP 2.2 Infeed transport belt
1
2
3
4
5
2.2.1
To Next Page
Loading...
