Plockmatic SR 85 - MAI 9.1 Preventive Maintenance

Bookletmaker SR 85 February 2001PAGE
MAI 9.1 Preventive Maintenance
CHECK POINT INSTRUCTION REFERENCE 125000 250000
All machine, Paper paths etc. Use a vacuum cleaner, Clean Clean
towels and brushes to
clean the machine from
paper dust. Use an
alcohol to clean from ink.
Stapler assy. drive bars (2 pcs.) Apply grease. Check Grease/
Check according to Adjust
REP 3.4.
Fold knife drive bars (2 pcs.) Apply grease between Page 1.13 Check Grease
vertical rods and Fold Item 10
knife plate.
Fold stop bars (2 pcs.) On square shaped bar Page 1.13 Check Grease/
holding the fold stop assy, Check
apply silicon grease on the
bottom side of the bars
(between the bar and the
ty-wrap). Check ty-wraps
for wear. If worn, replace.
Stapler motor crank arm (2 pcs.) Apply silicon grease Page 1.9 Check Grease
between Crank journal Item 14
and Rod.
Fold knife motor crank arm (2 pcs.) Apply silicon grease Page 1.13 Check Grease
between Crank elbow Item 12
and Rod.
O-ring for eject feed wheel Check for wear. If worn, Page 1.9 Check/Clean Replace
replace. Always replace Item 4
at 250 000.
O-ring for edge staple motor Check for wear. If worn, Page 1.5 Check Check
replace. Item 3
Chain Use chain oil. Check for Page 1.5 Oil Oil
wear, if worn/stretched Item 20
replace. Always replace
every 100 00 00.
Chain idler rollers (3 pcs.) Apply grease between Page 1.5 Check/Grease Replace
idler roller and pin. Check Item 12
for wear. If worn, replace.
Threaded adjustment rod Use grease at 500 000. Page 1.9 (Grease)
Item 10
9.1.1
Note: All INSTRUCTIONS are referring to the Bookletmaker SR 85 Service Manual.
The REFERENCE column is referring to the Spare parts list of Model SR85.