Bookletmaker SR 85 February 2001PAGE
CHECK POINT INSTRUCTION REFERENCE 125000 250000
Lower fold roller holder bracket Apply grease between the Page 1.5 Check/Grease Grease
(2 pcs.) spacer bracket and the Item 18
side frames. Check for
wear, if worn replace.
Upper fold roller bearings Under the top cover, use Page 1.5 Oil Oil/
(2 pcs.) oil between bearings and Item 10 Grease
shaft. Apply silicon grease
between bearing and side
frame.
Upper fold rollers Use a rubber reactivator Page 1.13 Clean Clean
alcohol fluid. Item 1
Stapler heads (2 pcs.) Check stapler heads by Grease/Check Replace
stapling 20 sheets. If poor
staple result, replace
stapler head. The poor
staple result is due to worn
driver points. Apply silicon
grease on plastic guide
posts and between top of
drive post and stapler drive
bracket. Use thin oil on
stapler driver
(without staining the paper).
Stapler retraction swing arm Apply silicon grease on Grease Grease/
(2 pcs.) bearing points. Check Adjust
adjustment according to
REP 3.6 when replacing
stapler heads.
Staple stop gate release arm Apply silicon grease on Page 1.9 Grease/
solenoid. SOL 2 both friction areas. Check Item 3 Check
that the stop gate latches
and releases correctly.
Continue MAI 9.1 Preventive Maintenance
9.2.1
To Next Page
Loading...
