Plockmatic SR 85 - REP 3.3 Staple stop gate position, adjustment

Bookletmaker SR 85 February 2001PAGE
PURPOSE
The purpose is to position the Staple stop gate fingers in the center of each opening in the
paper path so that binding does not occur.
1. Adjust to the smallest length size on the control panel.
2. Switch off the main power switch and disconnect the power cord.
3. Remove the Infeed cover according to REP 1.3.
4. Insert a 0.3 mm feeler gauge (3) to ensure 0.3 ± 0.2 mm endplay.
5. Disengage the Staple stop gate release solenoid (1). PO/PO
ADJUSTMENT
1. Check that the fingers (2) are centered in the openings in the paper path.
2. Loosen the two allen screws (4)(5) securing the collars.
3. Center the fingers (2).
4. Tighten the front allen screw(4).
5. Insert a 0.3 mm feeler gauge (3) to obtain 0.3 ± 0.2 mm endplay.
6. Tighten the rear allen screw (5).
REP 3.3 Staple stop gate position, adjustment
12 3
4
0.3±0.2 mm
3.3.1
VIEW INSIDE INFEED COVER
5