Plockmatic SR 85 - Table of Contents

Bookletmaker SR 85 February 2001PAGE
REPAIRS / ADJUSTMENTS (REP) PAGE
Cover removal
REP 1.1 Front and rear cover 1.1.1
REP 1.2 Top cover 1.2.1
REP 1.3 Panels + Infeeder 1.3.1
REP 1.4 Infeed and outfeed cover 1.4.1
Input area
REP 2.1 Infeed module 2.1.1
REP 2.2 Infeed transport belt 2.2.1
REP 2.3 Side guides 2.3.1
REP 2.4 Side guide assy. 2.4.1
REP 2.5 Side guide jogger motor MOT 3 2.5.1
REP 2.6 Back jogger motor MOT 7 2.6.1
Stapler area
REP 3.1 Stapler head 3.1.1
REP 3.2 Stapled set stop gate solenoid SOL 2 3.2.1
REP 3.3 Staple stop gate position, Adjustment 3.3.1
REP 3.4 Stapler assembly drive bar position, Adjustment 3.4.1
REP 3.5 Stapler home position, Adjustment SW 1 3.5.1
REP 3.6 Stapler head retraction, Adjustment 3.6.1
REP 3.7 Saddle stapling sensor, Adjustment SEN 1 3.7.1
Output area
REP 4.1 Upper folder roller 4.1.1
REP 4.2 Lower folder roller 4.2.1
REP 4.3 Fold pressure, Adjustment 4.3.1
REP 4.4 Fold knife home position, Adjustment SW 2 4.4.1
REP 4.5 Outfeed sensor, Adjustment SEN 4 4.5.1
Staple/Fold quality adjustments
REP 5.1 Staple stop gate parallelism, Adjustment 5.1.1
REP 5.2 Staple/Fold position, Adjustment 5.2.1
REP 5.3 Stapler position to anvil, Adjustment 5.3.1
REP 5.4 Stapler pressure, Adjustment 5.4.1
REP 5.5 Stapled set transport drive alignment, Adjustment 5.5.1
REP 5.6 Pressure roller height, Adjustment 5.6.1
REP 5.7 Stapled set stop gate release solenoid, Adjustment SOL 1 5.7.1
PROGRAMMING (PRG)
PRG 6.1 Reset of EE-prom values 6.1.1
ELECTRICAL DETAIL INFORMATION (EDI)
EDI 7.1 Wiring diagram SR85 7.1.1
EDI 7.2 Connection cable wiring diagram SR85 7.2.1
EDI 7.3 Electrical components list 7.3.1
EDI 7.4 Electrical components location 7.4.1
EDI 7.5 Test points 7.5.1
FAULT ISOLATING PROCEDURE (FIP)
FIP 8.1 Self diagnostic system control (SDS) 8.1.1
PREVENTIVE MAINTENANCE (MAI)
MAI 9.1 Preventive Maintenance 9.1.1
Contents
i