Join Calls to Create a Conference Call
You can join one active call and one held call into a conference call.
Procedure
» Do one of the following:
• When you have an active call and a held call, select the Join soft key.
• When you have an active call and more than one held call, select a held call and then select
the Join soft key.
The active call and selected held call join into a conference. If you have multiple held calls, the
other held calls on the line remain held.
End a Conference Call
By default, when you end a conference call, your connection to the call ends and the other participants in
the conference remain in the call. Your system administrator can set up your phone so that all
connections terminate when you end a conference call.
Procedure
» During a conference call, select End Call.
Hold a Conference Call
When you place a conference call on hold, you place all conference participants on hold.
Procedure
» Select Hold .
Resume a Conference Call
Resuming a held conference call enables all participants to hear the audio of everyone on the call.
Procedure
» Select Resume.
Split a Conference Call
When you split an active or held conference call, the conference ends and places the other two
participants on hold. You can then resume one of the held calls.
Procedure
» During a conference call, select the Split softkey.
The conference call ends, and the two participants are held in two separate calls.
Manage Conference Call Participants
If your system administrator enables the conference management on your phone, you can manage
conference call participants in the following ways:
Conference Calls
66
To Next Page
Loading...
